Operating instructions
15
Radiance
®
Direct Vent Gas Heater
20306759
ST720
Radiance
slide stove back
7/30/02 djt
ST720
Fig. 13 Slide stove back just far enough to access rear leg
holes.
Assembly Procedures
Failure to position the parts in accor-
dance with these diagrams or failure to
use only parts specically approved for
use with this heater may result in property damage
or personal injury.
This heater and components are heavy. Have help
available for assembly.
WARNING
Tools Required
• Phillips screwdriver (stub) • power drill
• utility knife • reciprocating saw
• metal drill bit: size 28 (.140"/3.5mm) • 9/16" wrench
• Flat-blade screwdriver
Parts Bag Contents:
•
(3) Vent Screws
• (2) Switch bracket screws
• Wood handle w/insert lifter
(handle for operable door)
• Restrictor Plate
• 4" Starter pipe
• On-Off switch, housing, and wiring harness
(3) Phillips round-head bolts, 1/4"- 20 x 1/2"
• (1) Tube of Vent Gasket Cement
• (4) CS, Hex Hd 3/8-16 x 1 Gr 2-Z
• (4) Washer, Fl 3/8-Z
• Owner Registration Card
• Homeowner’s Installation and Operating Manual
Unpack and Assemble Legs
The Radiance is shipped upright. Cut the shipping straps
before beginning assembly.
1. Slide stove to the rear of the pallet just far enough to
access rear leg holes. Make sure the stove does not
tip over backwards. (Fig. 13)
2. Attach the rear legs using 3/8" hex head bolts and at
washer supplied. Tighten with a 9/16" wrench or socket.
Remove and discard the large slot-head screws using
the at-blade screwdriver.
3. Carefully tip the stove onto its rear legs. Adjust the pallet
to allow access to one of the front leg holes. Be sure
to leave the pallet under the stove to prevent the stove
from falling fully forward. (Fig. 14)
CAUTION: To prevent valve tubing from being
crushed or damaged, do not rest valve or ignitor
on wooden pallet.
4. Have your assistant attach one leg using the hardware
described.
5. Move the pallet to allow access to the other front leg
hole. Attach remaining leg.
6. Remove pallet and allow stove to gently rest on all four
legs.
7. Adjust leg levelers to compensate for irregularities in
the hearth.
NOTE: Verify the two relief doors (located on top of the
rebox) are properly seated on the gasket. The doors
should sit ush on the gasket, and should lift easily
from the seal around the opening.
ST721
Radiance
attach
front legs
7/30/02 djt
Washer
Hex Head Bolt
Fig. 14 Carefully tip stove onto back legs. Leave pallet under
stove to keep stove from falling fully forward.
ST721