Operating instructions

9
ODGSR Series Outdoor Gas Fireplace
20007114
Remote Wall Switch
NOTE:Useanapprovedoutdoorswitch.
1.Threadwirethroughthelowvoltagewireaccesshole
locatedoneithersideofunit.Donotcutwireorinsula-
tiononmetaledges.Ensurethatwireisprotected.Run
theotherendtoaconvenientlylocatedwallreceptacle
box.
2.Attachwiretoswitchandinstallswitchintoreceptacle
box.Attachcoverplatetoswitch.
3.Connectwiringtogasvalve.RefertoFigure11.
CAUTION: Do not wire millivolt remote wall
switch for gas appliance to a 120v power
supply.
For lighting instructions, refer to Page 12.
NOTE: If glass doors are installed, the unit must be
operated with the doors fully open. (Fig. 12) If the doors
are not fully open, the thermodisk will automatically
turn the unit off.
CAUTION: After the unit cools, the burner will
automatically come on.
MD706-7
Glass Door Position
1/20/99
OPEN
Correct
Wrong
MD706-7
Fig. 12Correctdoorpositionduringoperation.
Pilot
Thermodisk
On/Off
Switch
Valve
HV105
Fig. 11 Remoteswitchwiring.
HV105
Generic Gas Valve
9/22/99 djt
TPTH
TH
TP