Operating instructions

ManualsBrandsVermont Castings ManualsLawn and GardenODGSR42A

Outdoor Gas Fireplace

Models:

ODGSR36A, ODGSR42A

PLEASE READ THIS MANUAL

BEFORE INSTALLING AND USING

APPLIANCE.

WARNING: If the information in this

manual is not followed exactly, a re or

explosion may result causing property

damage, personal injury or loss of life.

—Do not store or use gasoline or other

ammable vapors and liquids in the

vicinity of this or any other appliance

—WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electrical switch;

do not use any phone in your

building.

• Immediately call your gas supplier

from a neighbor's phone. Follow the

gas supplier's instructions.

• If you cannot reach your gas

supplier, call the re department.

—Installation and service must be

performed by a qualified installer,

service agency or the gas supplier.

WARNING: Improperinstallation,

 adjustment,alteration,serviceor

 maintenancecancauseinjuryor

 propertydamage. Read the installation,

operating and maintenance instructions

thoroughly before installing or servicing

thisequipment.

WARNING:

For Outdoor Use ONLY.

INSTALLER/CONSUMER

SAFETY INFORMATION

Homeowner'sInstallationand

OperatingManual

2000711410/13Rev.17

7114

ODGSR

cover

11/03

INSTALLER: Leave this manual with the appliance.

CONSUMER: Retain this manual for future reference.

Summary of content (20 pages)

PAGE 1
Outdoor Gas Fireplace Models: ODGSR36A, ODGSR42A INSTALLER/CONSUMER SAFETY INFORMATION PLEASE READ THIS MANUAL BEFORE INSTALLING AND USING APPLIANCE. WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. — Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance — WHAT TO DO IF YOU SMELL GAS • Do not try to light any appliance.
PAGE 2
ODGSR Series Outdoor Gas Fireplace Table of Contents Thank you and Congratulations on your purchase of a Vermont Castings Group fireplace. PLEASE READ THE INSTALLATION & OPERATING INSTRUCTIONS BEFORE USING THE APPLIANCE IMPORTANT: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible fire hazard and will void the warranty. Installation & Operating Instructions .................................................................
PAGE 3
ODGSR Series Outdoor Gas Fireplace General Information This gas appliance should be installed by a qualified installer in accordance with local building codes and with current CSA-B149.1 Installation codes for Gas Burning Appliances and Equipment. FOR U.S.A Installations follow local codes and/or the current National Fuel Gas Code. ANSI Z223.1/NFPA 54. In the Commonwealth of Massachusetts, all gas fittings and installation of this heater shall only be done by a licensed gas fitter or licensed plumber.
PAGE 4
ODGSR Series Outdoor Gas Fireplace Fireplace Dimensions 56O" (572mm) 22" (559mm) 6 " (822mm) 56O" 68 56O "( 17 6 " 40 (1 m 6m m m ) ) 4856O" (1232mm) 4856O" (1232mm) 56O" (13mm) " (559mm) Rough Opening Depth Rough Opening Height 39 6 " (1007mm) Rough Opening Width 41" (1041mm) 56O" (191mm) 43 6M" (1111mm) " (622mm) 36" (914mm) Low Voltage Wire Access Low Voltage Wire Access 1456M" (362mm) 856M" (210mm) 3 6M" (95mm) 1456M" (362mm) 6 " Recessed (16mm) Nailing Flange 40" (1016m
PAGE 5
ODGSR Series Outdoor Gas Fireplace Moisture Resistance This outdoor fireplace will shed moderate amounts of water, but is not waterproof. Water and condensing water vapor may enter the chase under certain conditions. The fireplace will not perform as an exterior wall. Moisture penetration must be considered for construction that places the fireplace in structure walls or on moisture sensitive surfaces.
PAGE 6
ODGSR Series Outdoor Gas Fireplace Hearths should slope away from the front of the fireplace and chase at 1/8 in to 1/4 in per foot. Metal safety strips must be on top of any combustible hearth materials used for moisture management. J CFM164 Black Surround Face I H Mantel Leg CFM164aSide of Combustion Chamber Mantel Leg Chart 06/22/01 sta M N O G Framing and Finishing F Check appliance to make sure it is levelled and properly positioned.
PAGE 7
ODGSR Series Outdoor Gas Fireplace Gas Specification Model ODGSR36ARN ODGSR36ARP ODGSR42ARN ODGSR42ARP Fuel Gas Control Nat. Prop. Nat. Prop. Millivolt Hi/Lo Millivolt Hi/Lo Millivolt Hi/Lo Millivolt Hi/Lo Max. Input 60,000 60,000 60,000 60,000 Min. Input 42,600 44,000 42,600 44,000 Gas Inlet & Manifold Pressures Minimum Inlet Pressure Maximum Inlet Pressure Manifold Pressure Natural 5.5” w.c. 14.0” w.c. 3.5”w.c. LP 11.0” w.c. 14.0” w.c. 10.0” w.c. FP1414 Fig. 5 Valve access.
PAGE 8
ODGSR Series Outdoor Gas Fireplace *Do not install header until unit is in place. Standoff Surround Gas Line Access Nailing Flange Screen Grate Firebox Valve Access Panel FP1416 Fig. 8 Parts identification. FP1416 Interior sides of an exterior chase ODUVSR part id should be weather proof 11/24/03 djt *Do not install header until unit is in place.
PAGE 9
ODGSR Series Outdoor Gas Fireplace Remote Wall Switch NOTE: Use an approved outdoor switch. Pilot 1. Thread wire through the low voltage wire access hole located on either side of unit. Do not cut wire or insulation on metal edges. Ensure that wire is protected. Run the other end to a conveniently located wall receptacle box. 2. Attach wire to switch and install switch into receptacle box. Attach cover plate to switch. 3. Connect wiring to gas valve. Refer to Figure 11.
PAGE 10
ODGSR Series Outdoor Gas Fireplace Operating Instructions Log Installation 1. Remove logs from the packaging. As with all plastic, these bags are not toys and should always be kept away from children and infants. 2. Place left rear log on rear log support. Ensure that log is firmly positioned and there is no side-to-side movement. (Figs. 13 & 14) 3. Carefully place Ember Log between grate and burner. (Figs. 13 & 14) 4.
PAGE 11
ODGSR Series Outdoor Gas Fireplace ELECTRON IGNITION Flame Adjustment 3/8"-1/2" For units equipped with Hi/Lo valves, flame adjustment is accomplished by rotating the Hi/Lo adjustment knob located near the center of the gas control. HI Turn counterclockwise to increase flame height LO Turn clockwise to lower flame height Fig. 15 Flame adjustment knob for SIT820 valve. NOVA SIT Pilot FP581 Fig. 16 Proper pilot flame height.
PAGE 12
ODGSR Series Outdoor Gas Fireplace Optional Weather Enclosure Optional Stainless Steel Hood An optional weather enclosure is available to protect the burner when not in use. An optional stainless steel hood is available for both the ODGSR36A and ODGSR42A. CAUTION: Do not use the weather enclosure if the unit has glass doors installed. NOTE: The stainless steel hood may NOT be used when the optional glass doors are installed. Installation Instructions 1. Turn the unit OFF and allow to cool. 2.
PAGE 13
ODGSR Series Outdoor Gas Fireplace Lighting and Operating Instructions FOR YOUR SAFETY READ BEFORE LIGHTING WARNING:If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This heater has a pilot which must be lit manually. When lighting the pilot follow these instructions exactly. B. BEFORE LIGHTING smell all around the heater area for gas.
PAGE 14
ODGSR Series Outdoor Gas Fireplace Troubleshooting Nova SIT 820 Standing Pilot START Gas Supply On CHECK NO YES Pilot Lights with Piezo Ignitor NO Supply Line Hooked up Shutoff Valve Open Lockout has engaged. Wait 60 seconds and try again. Piezo not tight enough for good ground. For spark at electrode while depressing Piezo (Red Button) 1/8" gap to pilot hood needed.
PAGE 15
ODGSR Series Outdoor Gas Fireplace Maintenance Burner and Burner Compartment It is important to keep the burner and the burner compartment clean. At least once per year the logs should be removed and the burner compartment vacuumed and wiped out. Remove and replace the logs as per the instructions in this manual. Always handle the logs with care as they are fragile and may also be hot if the fireplace has been in use.
PAGE 16
ODGSR Series Outdoor Gas Fireplace 1. ODGSR36A Logs a b 1. ODGSR42A Logs b 4a/b 2 a d e c d 3 c h f g 25 7 6 9 10 11 12a/b 8 16 19a/b E A THTP 20 22 13 TP LO OFF OF F TH HI ON 17 21 14 15 O PIL T 18a/b 7114 Vermont Castings Group reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. ODGSR36A, ODGSR42A Ref. 1. 1a. 1b. 1c. 1d. 1e. 1f. 1g. 1h. 2. 3. 4a. 4b. 6. 7. 8. 9. 10. 11. 12a.
PAGE 17
ODGSR Series Outdoor Gas Fireplace ODGSR36A, ODGSR42A (continued) Ref. 14. 15. 16. 17. 18a. 18b. 19a. 19b. 20a. 21. 22. 23. 24. 25.
PAGE 18
ODGSR Series Outdoor Gas Fireplace Accessories The following accessories are available from your local Vermont Castings Group Fireplaces distributor. Each accessory comes with a separate installation instruction for mounting to the particular firebox. Be sure to read each instruction thoroughly before installing.
PAGE 19
ODGSR Series Outdoor Gas Fireplace LIMITED LIFETIME WARRANTY PRODUCT COVERED BY THIS WARRANTY All Vermont Castings gas stoves, gas inserts, and gas fireplaces, and all Monessen and Vermont Castings Group brand gas fireplaces equipped with an Insta-Flame Ceramic Burner, or standard BASIC WARRANTY Vermont Castings Group (hereinafter referred to collectively as the Company) warrants that your new Vermont Castings, Monessen or Vermont Castings Group Gas Fireplace/Stove is free from manufacturing and material de
PAGE 20
Vermont Castings Group 149 Cleveland Drive • Paris, Kentucky 40361 www.vermontcastingsgroup.