Owner`s manual
20013055 7/05 Rev. 0
11
Fire Risk
Explosion Risk
Personal Injury Risk
Failure to position the parts in accordance
with the diagrams provided with the log
packages or failure to use only parts
approved with this appliance may result in
property damage or personal injury.
WARNING
F. Install the Logs
G. Adjust the Pilot Flame
The pilot ame should be a soft blue color and should sur-
round the last 1/2 in. of the thermocouple tip. The pilot ad-
justment screw is located on pilot valve beside control knob.
Refer to Figure 4.3. If pilot ame must be adjusted, use a
standard slotted screwdriver to turn screw clockwise to re-
duce ame or counterclockwise to increase ame.
• Install the logs using the installation instructions included
with them.
• Light the burner as outlined in the operating section. Allow
the ame pattern to stabilize. If you are satised with the
ame pattern go to the next step. If you want more or less
ame around the front log, turn off the gas and move the
grate backward or forward.
• Once you are satised, turn on the gas and go on to the
next step.
• Arrange the top logs as shown in your log set up
instructions. Light the burner as outlined in the operating
instructions and allow the ame to stabilize.
• Spread the lava rock around the outside of the burner
pan on the oor of the replace. If possible, cover the gas
connector with the cinders. DO NOT cover any part of the
pilot assembly.
Figure 4.3 Pilot Adjustment Screw
MO18 MO24
Step 1
Step 3
Step 2Step 2
Step 1
Step 3