Owner`s manual

20013055 7/05 Rev. 0
10
B. Install the Burner/Pan Assembly
The burner/pan assembly is shipped ready for left-hand gas
connection. See Section 3.B. for right-hand connection.
• Remove the existing cap or gas jet assembly from the
gas stub in your replace. Clean the threads using a wire
brush or steel wool. Apply Teon tape or joint compound
to the steel tting and attach the provided brass adapter
to the stub.
• Place the burner/pan assembly in the replace. The pan
should be centered both front to back and side to side.
• Bend the provided gas connector to facilitate its installation
between the burner and the gas stub.
• Attach one end of the gas connector to the brass elbow
or safety pilot tting. Attach the other end to the brass
adapter at the gas tube.
D. Install the Burner Pan and Grate
• The burner pan should be centered under the existing
grate, side to side. The center leg of the grate should be
positioned in front of the burner tube so as to ensure proper
placement and proper ame position. Refer to Figure 4.2.
Note: For easy placement, tilt grate up and hold burner
pan at 45 degree angle starting with back left corner of
burner pan.
Figure 4.2 Center Burner Pan Under Grate
E. Place Sand/Vermiculite, Rockwool
• Pour the sand (NG models) or vermiculite (LP models)
into the burner pan. Sand or vermiculite should follow the
slope of pan, covering it and the burner tube completely.
Note: Use caution so vermiculite does not get into the air
mixer on LP models.
• Allow the sand or vermiculite to spill out the front of the
pan and over the sides onto the replace oor.
Important: Cover the pilot assembly to protect it before
installing the sand or vermiculite.
Explosion Risk
• Follow rockwool placement instructions
in this manual.
• Replace rockwool material annually.
Improperly placed rockwool interferes with
proper burner operation.
WARNING
C. Switch or Remote Installation
• Remote - follow instructions included with it.
• Switch:
- Plug in two wires from the switch to wires on valve.
Note: For best results, do not pack down the rock wool.
The placement of rock wool can have an effect on ame
pattern and may need to be adjusted to achieve a desired
appearance.
• The gas burns at the point of the least resistance. In case
of an uneven ame pattern it may be necessary to adjust
the materials in the pans (using an object such as a long
screwdriver) to achieve the desired effect.
• Lightly place dime-sized pieces of rockwool evenly on top
of the sand or vermiculite.
• Inspect the pilot burner to ensure it is clear of any
rock wool.