Operating instructions
30
75D0004
MLDV Series Gas Fireplace
A remote wall switch and up to fteen (15) feet of 18 Ga.
wire may be used with this appliance. Attach the wall
switch in a junction box at the desired location on the
wall. Figure 48. Do not extend beyond the wall switch wire
length provided.
NOTE:
Figure 48 -
Wiring Diagram for Wall Switch
FP1912
Junction box wiring
8/08
Figure 49 -
Junction Box Wiring Diagram
10V AC
60Hz
Factory Supplied
Not Supplied
ON
OFF
OPTIONAL REMOTE
WALL SWITCH
ON
OFF
OPTIONAL REMOTE
WALL SWITCH
PILOT
HI
LO
ON
OFF
TH
TP
TH/TP
ON
OFF
RS
FP1980
Dv wiring diagram
1. Before installing the blower, wire the receptacle into an
electrical circuit. This should be done before framing
the replace. Wire with minimum 60° C wire in accor-
dance with prevailing codes.
. Remove the external junction box cover by removing
the screw from the left side of the outside rebox wall.
Junction box was installed at the factory.
3. The junction box cover has a factory installed “romex”
style strain relief connector. After connecting the wires,
route the wire leads through this connector. Refer to
the wiring diagram in Figure 49.
1. Always turn off the gas supply and allow the unit to
cool down before proceeding.
. Clean the inside of the rebox (wall and oor), where
the blower and wires will be installed. Make sure the
rebox wall and oor are clean and dry before mount-
ing the blower.
1. Remove the lower access panel by pulling up and
away from unit.
. Remove glass frame by releasing the two () latches
(500 Model has three (3) latches) below the rebox
opening and lifting glass frame up and away from
unit.
3. Remove logs.
4. Remove grate from engine by lifting up.