Operating instructions
36
51D0528
LX Series Direct Vent Gas Fireplace
and
Make sure the gas valve knob is in the “OFF” position.
Wait at least ve (5) minutes before start-ing maintenance.
Fireplace must be cold before starting maintenance.
A qualied agency should examine the venting system
annually.
Clean the ceramic glass periodically. Condensation will
sometimes form on the glass during a cold startup. This
is normal for all gas replaces. This condensation often
attracts dust and lint to the surface of the glass. The initial
paint curing of the appliance can also leave a slight lm
on the glass.
Your should clean the glass after the rst two weeks of
use. After that, you should clean the glass no more than
two or three times a season. Use a mild glass cleaner to
clean the door.
Visually check pilot and burner ames periodically. Refer
to Figure 54 for typical burner ame. Refer to Figure 55
for typical pilot ame.
1. Carefully remove log set, and embers from combustion
chamber.
2. Vacuum burner compartment thoroughly.
3. Vacuum any dust off logs.
4. Remove any lint from main burner and pilot.
5. Carefully replace log set, and embers in their correct
positions. Page 28
6. Replace door (if it has been removed).
7. Relight pilot. Page 35
8. Turn on main burner.
LG812
LX log flames
FP2721
pilot flame
Thermocouple
Thermopile
FP2721
Figure 54 -
Typical Pilot Flame
Figure 55 -
Typical Burner Flame
Appearance
LG812