Operating instructions
Intrepid® Direct Vent - Rear Vent Gas Heater
20012761
WARNING:
•   Always  maintain  required  clearances 
(air spaces) to nearby combustibles to 
prevent re hazard. Do not ll air spaces 
with  insulation.  All  venting  components  must 
maintain  a 1” (25 mm) clearance to combustible 
materials. Maintain a 6” (152 mm) clearance when 
using  single  wall  pipe.  Maintain  a  2”  (51  mm) 
clearance on top and 1” (25 mm) on sides and 
bottom when venting straight off the rear.
• The  gas  appliance  and  vent  system  must  be 
vented  directly  to  the  outside  of  the  building 
and never be attached to a chimney serving a 
separate solid fuel or gas-burning appliance. 
• Refer to the manufacturer’s instructions included 
with the venting system for complete installation 
procedures.
Installation Requirements
The installation should be done by a qualied service 
person  who  is  familiar  with  the  building  codes  and 
installation  techniques  appropriate  for  your  area  to 
accomplish a safe and effective installation.
Your dealer or your local gas supplier will be able to 
refer a qualied service person.
WARNING:    Due  to  high  temperatures,  the  HEATER 
should be located  out of trafc and away 
from furniture and draperies.
The  surface  of  the  Heater  is  hot  when  it  is 
in  use. Young  children  should  be  watched  carefully 
when they are in the same room when the Heater is 
in  use,  and  they  should  be  taught  to  avoid  the  hot 
surface.    Keep  any  objects  that  can burn  well away 
from the Heater, and observe the recommended clear-
ances that follow.
7!2.).'
(/4',!337),,
#!53%"52.3
$/./44/5#(',!33
5.4),#//,%$
.%6%2!,,/7#(),$2%.
4/4/5#(',!33
Locating the Stove
 
 
 
 
NOTE:
A
B
C
D
ST936
Stardance rear vent
Stove locations
6/07 djt
Fig. 2
Clearance Requirements
Minimum Clearances to Combustible Materials
  










