Operating instructions
Intrepid® Direct Vent - Rear Vent Gas Heater
20012761
Important: All vent clearances must be maintained.
Check your vent termination clearances against Fig-
ures 11 and 12.
IMPORTANT
Vent Termination Clearances
• Vermont Castings Group does not require any open-
ing for inspection of vent pipe.
• Only venting components specically approved and
labelled for this stove may be used.
• Minimum clearances between vent pipes and com-
bustible materials is one (1”) inch (25mm), except
where stated otherwise.
Location of Vent Termination