Specifications

DFS Series Vent Free Fireplace
16
71D0532


If you are installing the forced air blower kit, refer to the
installation instructions provided with the kit. The rebox
must be connected to main power supply at time of re-
box installation. The electrical connections must be made
before the rebox is framed and enclosed in the nished
walls.

   
     



     
    



BLACKBLACKWHITE
GREEN
BLACK
BLACKWHITE
Receptacle
Junction
Box
120VAC
Speed Control
FP2675
BLOT blower wiring


FP2675

1. This should be done before framing the replace. Wire
the receptacle into an electrical circuit. Wire with mini-
mum 60° C wire in accordance with prevailing codes.
2. Remove the external junction box cover by removing
the screw from the side of the outside rebox wall.
Junction box was installed at the factory.
3. The junction box cover has a factory installed “romex”
style strain relief connector. After connecting the wires,
route the wire leads through this connector. Refer to
the wiring diagram in Figure 16.
FP1912
Junction box wiring
8/08


Junction Box
Factory Supplied
Not Supplied
120V AC
60Hz