Specifications

11
Vermont Castings Intrepid
®
III Multi-Fuel
30003891


Carefully remove the outer packaging carton from the
stove and pallet . Remove the loose items from inside
the stove. Check the contents as listed, see diagrams
below :
 Contained inside polythene bag:
3, Handles ( door, shaker grate, damper)
4, Leg securing bolts
4, Leg securing washers
1, Door handle storage bracket (secures under front
right hand leg fixing bolt)
1, Large Allen key
1, Small Allen key
1, Shaker grate handle bracket
, Shaker grate handle bracket securing nuts
3, Self tapping screws (to secure fluepipe connector

4, Legs packed in bubble wrap
1, Poker/slicer
3, Grate insert plates (for wood burning)
 No optional short legs are available for the
Intrepid stove.

This stove is very heavy and therefore requires careful
handling both to avoid injury and damage to the stove.
Carefully lift up and remove the griddle plate from the
top of the stove, and place in a safe place pending
installation. (Fig. 1)
Remove the wood burning grate inserts and the wood-
en packaging piece from inside the stove firebox. (Fig.
13)
34
)-&)))
REMOVEGRIDDLE

Griddle
Plate
ST890
 Carefully remove griddle plate.
3T
BURNGRATE

ST891
 Remove burn grates.
Carefully remove the wood strips that secure the stove
to the pallet during transit.
Carefully manoeuvre the stove on the pallet in to a posi-
tion that allows it to be safely tilted backwards while still
resting on the pallet. This will prevent damage to the
rear of the stove or the floor, and allow access to the
base of the stove for attaching the legs.
Remove the four screws at each corner of the base of
the stove. Secure each leg in place at all four corners
of the stove using the bolts and washers provided in
the hardware bag. Note that the door handle storage
bracket must secure to the front left hand leg on this
model.
34
INSTALLLEGS

Door Handle Storage
Bracket
ST89
 Attach dooor handle storage bracket to front left leg.
Attach the shaker bar (riddling grate) handle bracket to
the threaded spindle on the right hand side of the base
of the stove using the two () locking nuts provided in
the hardware bag, (Fig. 15)
To facilitate ease of lifting of the stove, it may be help-
ful to remove all of the firebrick and grate components
from the stove before lifting in to the final installed posi-