Operation Manual

DX2 Operator control
vD - 2013-04
4
Using battery charge indicator
The battery charge indicator is used to indicate that your wheelchair power is on
and provides an estimate of the remaining battery capacity.
Any green LED's indicate that your batteries are well charged.
If only amber and red LED's are light, the batteries are moderately charged.
Recharge your batteries before you make a long trip.
If only red LED's are light, the batteries are running out of charge. Recharge as
soon as possible.
The following table indicates what the battery charge indicator will display.
Display Description Meaning Remarks
All LEDs dark. System off.
All LEDs are
flashing.
System on. Warning: battery too full.
Slow down if you are
driving down a slope.
All LEDs are lit. System on. LEDs show the charge
level.: Full battery
Only red and yellow
LEDs lit.
Low battery level. Battery half full. Start the
return journey.
Only red LEDs lit. Very low battery level. Battery low. Recharge
soon.
Red LEDs are
flashing.
Battery almost empty. Recharge now.
1 Red Led is
flashing.
Battery empty. Recharge immediately.
The LEDs turn on
one by one from left
to right.
Drive inhibit, the chair will
not drive.
The LEDs turn on
one by one from left
to right, followed by
one second where
the current battery
capacity is
displayed.
The charger is connected to
the operator control.
All leds turn on one
by one from left to
right. The Fault
indicator will show
corresponding flash
code.
Indicate that the chair will
not drive.
A fault has occurred.