User Guide Stream TV Product & Accessories Information F3544K49201
Verizon Stream TV Device HDMI Cable INPUT OK GUIDE 1 2 3 4 5 6 7 8 9 INFO 0 APPS RCU USB Cable + Power Adapter Batteries (The remote control uses two AAA heavy duty batteries)
Your Stream TV Top Side INPUT Top Button OK Front Side GUIDE System LED Rear Side HDMI USB HDMI POWER USB Out 2.
Set Up Device Before you start, confirm you have: • A Wi-Fi internet connection. • A Google account. A Google account is recommended but not required. The user will be able to skip the Google ‘sign in’ step. Step1 HDMI USB 1. 2. 3. 4. Connect the HDMI cable from your Stream TV to your TV. Connect the power cord from your Stream TV to an electrical outlet. Turn on your TV. Set your TV to the correct HDMI input. Refer to the TV manufacturer for help verifying HDMI input. 5.
Manually Add a Wi-Fi Network 1. From the Stream TV Home screen, select the Settings menu Utilize 5-way navigation pad on the remote to highlight and the center (OK) button to select. 2. Select View more 3. Select Network & Internet .
4. From the 'Available networks' section, select the preferred Wi-Fi network. If the preferred network is not listed, it can be added manually. 5. If presented, enter the appropriate password then select CONNECT.
Manually Pairing Your Stream TV Voice Remote Note: Only needed when replacing previously paired Steam TV Voice Remote 1. Press and hold the Top button for 3 seconds. Top Button 2. 3. 4. Press and hold the “Play\Pause” and “0” buttons on remote control simultaneously for 6 seconds. Release the buttons to enter pairing mode. If the 'pairing your remote' screen doesn't display, place the Stream TV in Bluetooth® discovery mode with the existing voice remote or the remote control app.
Function key Information HDMI USB Reset Button Top Button Find my remote BT paring Double click top button in 1 seconds Press and hold top button for 3 seconds for manually pairing System LED
Status Detail No power Bootup Indication Duration Not connected to power Off Until turned On Connected to power Soft Blink White Not connected to internet Accepting remote commands Error (FW or HW critical failure) User clicks buttons on remote Indication Priority Solid Red Until connected to internet LED OFF (blink) For 100ms after each remote click Hard Blink Red
WALL MOUNTING Information The device can be mounted onto a flat surface such as a wall or the back of a TV. For wall mounting, the device must not be mounted higher than 2 meters above the floor.
WALL MOUNTING Install Guidance 1 1. Using 2pcs screws to fix bracket onto wall Step 1 Step 2 2.
WALL MOUNTING Install Guidance 2 1. Assemble with bracket Step 1 Step 2 2. Tear off the release papers of two adhesive strip (the adhesives are intended to be used once) 3.
FCC Statement: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
