Setup guide

Step 3: Connect the Power Adapter

a. Plug one end of the power adapter into the power port on the

back of the Pan/Tilt camera.

b. Plug the other end into a power outlet.

Only use the power adapter provided. Using a

different adapter may cause hardware damage.

Step 4: Visit the Online Setup Wizard

a. Visit http://monitoringcontrol.verizon.com and follow the simple

steps provided in the online setup wizard. This will enable you to

add your device to the Home Control network

This will enable the Wired interface. Wireless and

Wired interfaces cannot be used simultaneously.

Using the Wired interface is recommended for initial

configuration. After you configure the Wireless

settings of the Pan/Tilt Camera via the setup wizard

and ensure they are correct, you can unplug the

Ethernet cable and power off the camera. The

camera will be in Wireless interface when you

power on the camera again.