Technical data

7.4.2 Commands and Messages

Setting the operating mode of sources A and B (see 6.2)

OPER_IND - setting of the operating mode INDEPEND (Independent Mode)

OPER_TRAC - setting of the operating mode A-B TRAC (Tracking Mode)

OPER_PAR - setting of the operating mode A-B PAR (Parallel Mode)

OPER? - Current operating mode OPER_IND, OPER_TRAC or OPER_PAR is

saved in the output buffer.

Selecting the sources for the following settings

SEL_A - selection of source A

SEL_B - selection of source B

SEL? - Current selection SEL_A or SEL_B sources A and B is saved in the

output buffer.

Setting the function mode of sources A and B (see 6.3)

CONT_CV - the source works off a constant voltage source

CONT_CC - the source works off a constant current source

CONT? - Current selection CONT_CV or CONT_CC of the function mode is

saved in the output buffer.

Voltage setting of the selected source

VSET xxxxx - voltage setting in the range (xxxxx) from Ø.ØØ to 3Ø.ØØ

VSET_MIN - voltage setting on Ø.ØØ V

VSET_MAX - voltage setting on 3Ø.ØØ V

VSET? - Voltage setting V xxxxx is saved in the output buffer.

VOUT? - Measured voltage value V xxxxx is saved in the output buffer.

Note

: When the selected source works off a constant current source and the

command VSET? is transmitted, the displayed voltage represents the value

of voltage limit.

Current setting of the selected source

ISET xxxxx - current setting in the range (xxxxx)

a) from Ø.ØØ1 to 2.3ØØ for the operating mode INDEPEND and

A-B TRAC

b) from Ø.3ØØ to 4.6ØØ for the operating mode A-B PAR

ISET_MIN - current setting to

a) Ø.ØØ1 A for the operating mode INDEPEND and A-B TRAC

b) Ø.3ØØ A for the operating mode A-B PAR

Operating Instructions PN 300

1/99