Technical data

6.6.1 Storing the Pre-settings
The input of the parameters and functions is set as described in sections 6.2 to 6.5.
After pressing the MEM button [11] the sub-menu for storing and loading the unit settings is
set. On pressing cursor buttons “
∧” and “∨” [13] the menu point for saving the unit settings is
called and the following message appears on the display [5]:
MMEM
[ STORE ]
With the help of the ENTER button [12] the menu point is confirmed and the following
message is displayed:
STORE
SET#: [ ]
The term in the brackets [ ]describes the current memory place where the setting are saved.
On pressing cursor buttons “∧” and “∨” [13] the desired memory place (#) from 1 to 5 is set
and the ENTER button [12] must be pressed. The following query appears on the display:
Are you sure ?
and the settings can be corrected. If the former state is to be kept, the ESC button [12] has to
be pressed. The new setting is saved with the ENTER button [12]. In both cases the unit
reverts to the starting state.
6.6.2 Loading the Pre-settings
After pressing the MEM button [11] the sub-menu for storing and loading the unit settings is
accessed. On pressing cursor buttons “
∧” and “∨” [13] the menu point for loading the unit
settings is called and the following message appears on the display [5]:
MMEM
[ LOAD ]
With the help of the ENTER button [12] the menu point is confirmed and the following
message is displayed:
LOAD
SET#: [ ]
The term in the brackets [ ]describes the current memory place where the settings are saved.
On pressing cursor buttons “
∧” and “∨” [13] the desired memory place (#) from 1 to 5 is
selected and the ENTER button [12] must be pressed for confirmation. The following query
appears on the display:
Are you sure ?
20
Operating Instructions PN 300
1/99