Specifications

Troubleshooting

LTE Broadband 11n Wireless Router MBR1515

• If your ISP assigned a host name to your computer, enter that host name as the account

name in the Basic Settings screen.

• Y

our ISP could be rejecting the Ethernet MAC addresses of all but one of your

computers. Many broadband ISPs restrict access by allowing only traffic from the MAC

address of your broadband modem, but some ISPs additionally restrict access to the

MAC address of a single computer connected to that modem. If so, you must configure

your router to clone or spoof the MAC address from the authorized computer. See the

LTE Broadband 11n Wireless Router MBR1515 Installation Guide.

Problems with Date and Time

The Schedule screen displays the current date and time of day. The LTE Broadband 11n

Wireless Router uses the Network Time Protocol (NTP) to obtain the current time from one of

several network time servers on the Internet. Each entry in the log is stamped with the date

and time of day. Problems with the date and time function can include the following:

• Dat

e shown is January 1, 2000.

Cause: The router has not yet successfully reached a network time server. Check that

your In

ternet access settings are configured correctly. If you have completed configuring

the router, wait at least 5 minutes, and check the date and time again.

• T

ime is off by one hour.

Cause: The router does not automatically sense

daylight savings time. On the Schedule

screen, select or clear the Automatically Adjust for Daylight Savings Time check box.

Restore the Default Configuration and Password

This section explains how to restore the factory default configuration settings, changing the

router’s admin password to password and the IP address to 192.168.0.1. You can erase the

current configuration and restore factory defaults in two ways:

• Use the

Erase feature (see Erase the Configuration on page 48).

• Pre

ss the Restore Factory Settings button on the bottom of the router for 6 seconds.

Use this method for cases when the administration password or IP address is not known.

The factory default settings are shown in Factory Default Setting

s on page 83.