Specifications

Advanced Settings

LTE Broadband 11n Wireless Router MBR1515

Wireless repeater. The router sends all traffic from its local wireless or wired computers to a

remote access point. To configure this mode, you have to know the MAC address of the

remote parent access point.

The MBR1515 router is always in dual-band concurrent mode, unless you turn off one radio.

When you

enable the wireless repeater in either radio band, the wireless base station, or

wireless repeater, cannot be enabled in the other radio band. However, if you enable the

wireless base station in either radio band and use the other radio band as a wireless router or

wireless base station, dual-band concurrent mode is not affected.

For you to set up a wireless network with WDS, the followin

g conditions have to be met for

both access points:

• Both access

points have to use the same SSID, wireless channel, and encryption mode.

• Both access

points have to be on the same LAN IP subnet. That is, all the access point

LAN IP addresses are in the same network.

• All LAN devices (wired and wireless computers) have to be configured to operate in the

same LAN ne

twork address range as the access points.

Wireless Repeating Function

Select ADVANCED > Advanced > Wireless Repeating to view or change wireless repeater

settings for the router.

• Enable Wireless Repeating Function. Select the check box for the 2.4 GHz or 5 GHz

network to use the wireless repeating function.

• Wireless MAC of this router. This field displa

ys the MAC address for your router for your

reference. You need to enter this MAC address in the corresponding Wireless Repeating

Function screen of the other access point you are using.

• W

ireless Repeater. If your ro

uter is the repeater, select this radio button.