User guide

Troubleshooting
89
Verizon 4G LTE Broadband Router
Basic Functioning
After you turn on your router, the following should occur:
1. W
hen power is first applied, make sure that the Power LED is lit.
2. Af
ter approximately 10 seconds, look for the following:
a. T
he Power LED is still solid green. An amber LED indicates that the router has failed
its power-on self-test (POST).
b. T
he Internet Port LED is lit.
c. The W
i-Fi LED is lit.
d. T
he Ethernet LAN Port LED is lit when any local ports are connected.
If a local area network (LAN) port’s LED is lit, a link
has been established to the
connected computer. If a LAN port is connected to 100-Mbps equipment, the port’s
LED is green. If the equipment is 10 Mbps, the LED is amber.
e. T
he Ethernet wide area network (WAN) Port LED is lit when the router is connected
to a wired modem.
f. T
he Signal Quality LED is lit when the router has detected a mobile broadband
signal.
• A b
lue LED indicates excellent coverage.
• A g
reen LED indicates good coverage.
• An
amber LED indicates poor coverage.
If any of these conditions do not occur
, see the following table.
Table 1. LED indicators
LED Action
Power Power LED is off. • Make sure that the power cord is correctly connected to your router,
and that the power supply adapter is correctly plugged into a working
power outlet.
• Check that you are using the power adapter supplied for this product.
• If the error persists, you might have a hardware problem and should
cont
act technical support.
Power LED is
amb
er.
POST (power-on self-test) is in progress. Wait for this test to complete.