User guide

441

63. What happens if I get a new vehicle?

You can move the device to a new vehicle and, after performing the normal vehicle setup per the

instructions, you will see the new vehicle listed in the app and portal. You will need to check the

Fitment Guide (at connectedcar.delphi.com/ﬁtment) for compatibility. If supported by your new

vehicle, you will also be able to pair your vehicle’s key fob.

Note: You will only be able to pair the Vehicle Diagnostics key fob with two vehicles at any one

time. See question How many key fobs can I can the Vehicle Diagnostics Module support?

64. I unplugged my device before I took it to the dealership. How do I re-install it? Do I have to

do everything again?

Follow the instructions in section “Vehicle Diagnostics Removal & Re-Pairing Procedure” of the

Reference Guide.

65. Why do the lights on the Vehicle Diagnostics Module change color while I drive?

The Vehicle Diagnostics Module status LED indicates data transmission which is fully explained

in the Reference Guide and Device Manual.

66. Why does my Vehicle Diagnostics Module only show a blue light?

If you have not performed the vehicle setup steps described in the Reference Guide or the User

Manual with the ignition on, this must be completed ﬁrst. If you have completed those steps and

you still have a solid blue LED, your vehicle may currently be incompatible. Check the Fitment

Guide at connectedcar.delphi.com/ﬁtment.

67. I have unplugged the unit from my vehicle and plugged it back in, what do I need to do?

If the LED is solid blue, then begin with step 5 in the Quick Reference Guide (QRG) to

re-initialize your Vehicle Diagnostics Module. If the LED is not solid blue, disconnect the unit

from your vehicle, wait 10 seconds, reconnect it and wait for the solid blue LED (about 25

seconds), begin with step 5 in the Quick Reference Guide (QRG) to re-initialize your Vehicle

Diagnostics Module.