User guide

385

Key Fob Pairing

The key fob setup process has two main steps, conﬁguring your Vehicle Diagnostics Module for

your vehicle and pairing your Vehicle Diagnostics Module with your vehicle. You can perform the

conﬁguration step at any time from either the smartphone app or the website. To complete the

pairing step you will need to be in your vehicle. It is necessary to perform this step in your ve-

hicle because you may be prompted at times to turn your ignition key and press speciﬁc vehicle

buttons. Following the successful set up of your Vehicle Diagnostics Key Fob, you will be able to

use the smartphone app to send key fob commands to your vehicle in the same manner as you

would with your original key fob. In addition, you can use the Delphi Connected Car website to

send key fob commands as well.

Note: While the Vehicle Diagnostics Module currently supports most remote start systems that came from

the manufacturer, you can check if your remote start feature is supported. Refer to the ﬁtment guide at

connectedcar.delphi.com/ﬁtment. For vehicles that require a sequence of buttons to be pressed to perform

a remote start, you only need to press the Remote Start button once. The Vehicle Diagnostics Module will

automatically provide any button sequence required to start the vehicle.

Note: You will only need to pair the key fob using the Delphi Connected Car app or website one

time. After the initial pairing, the key fob capability will be available from either location.

Note: For vehicles that require a sequence of buttons to be pressed to perform a remote start, you only need

to press the Remote Start button once. The Vehicle Diagnostics Module will

automatically provide any button sequence required to start the vehicle.

Note: The key fob setup should be only performed when all key fobs are present. If you do this

with only one present it may de-program your secondary key fobs.