User guide
11
Step 5: Initiate Vehicle Diagnostics Module
Setup
Stop! Do not proceed until the Status LED is solid
blue, indicating activation on the Verizon network.
• Insert your vehicle’s ignition key and turn it to the
On position (not ACC/Accessory). Do not start the
engine!
- For pushbutton-start vehicles, the procedure is
typically to push the start button without your
foot on the brake (check your vehicle owner’s
manual to determine how many presses are
required to turn the ignition on).
• Press and hold the Function Button on the side of
the Vehicle Diagnostics Module for approximately
5 seconds, until the status LED blinks red one
time. Then release the Function Button. The LED
will blink red while vehicle setup occurs.
• Waitupto30secondsfortheLEDtobecome
green
– First solid green and then blinking green.