User guide

Step 4: Install Your Vehicle Diagnostics

Module

• Plug the Vehicle Diagnostics Module into the

OBD II port. Make sure that the Vehicle

Diagnostics Module is fully seated.

• Wait for the Status LED to turn solid blue.

NOTE: The first time the module connects to the Verizon network, it will

perform a one-time network setup which will take a few minutes.

Once the one time network setup begins, the Status

LED will turn solid white then turn off, followed by

a blinking white sequence. When network setup is

successfully completed, the Status LED will turn solid

blue.

For Helpful Installation Tips –

(See verizonwireless.com/vehiclediagnostics)