User guide

030-300239 Rev. A 9 March 2008
Verizon FiOS Router
(
Model 9100VM
)
User Guide
5. HARDWARE FEATURES
5.1 LED Indicators
This section explains the front-panel and rear-panel LED states and descriptions. LEDs are used to verify the unit’s
operation and status.
LED States and Descriptions
Verizon FiOS Router Front Panel LEDs
LED State Description
Solid Green Power is ON.
Flashing Green Router is performing POST.
Solid Red
Router failed POST (Power On Self Test) or Device Malfunction.
Note: The Power LED should be red no longer than two seconds
after the power on self test passes.
POWER
OFF Power is OFF.
Solid Green VDSL2 link established.
Flashing Green VDSL2 attempting to sync.
Solid Red Router failed to sync.
BROADBAND
OFF Router power is OFF or no VDSL2 signal detected.
Solid Green
Internet link established. VDSL2 link is Up, and the Router has a
WAN IP address from IPCP or DHCP; or a static IP is configured;
or PPP negotiation has successfully completed (if used) and no
traffic is detected.
Flashing Green
IP connection established and IP Traffic is passing through device
(in either direction). Note: If the IP or PPP session is dropped due
to an idle timeout, the light will remain solid green, if a VDSL2
connection is still present. If the session is dropped for any other
reason, the light is turned OFF. The light will turn red when it
attempts to reconnect and DHCP or PPP fails).
Solid Amber
Router has attempted and failed to establish IP connectivity (no
DHCP response, no PPP response, PPP authentication failed, no
IP address from IPCP, etc.).
INTERNET
OFF
Router power is OFF; or Router is performing POST; or Router is
in Bridge Mode; or Router has not attempted Internet connectivity.
Solid Green Wireless link established.
Flashing Green
Wireless LAN activity is present (traffic in either direction).
IP connection established and IP traffic is passing through device
(in either direction). Note: If the IP or PPP session is dropped due
to an idle timeout, the light will remain solid green, if a VDSL2
connection is still present. If the session is dropped for any other
reason, the light is turned OFF. The light will turn red when it
attempts to reconnect and DHCP or PPP fails).
WIRELESS
SETUP
OFF
Router power is OFF; no wireless link; or wireless Easy Config
not active.
Solid Green Powered device is connected to the associated port. 1,2,3,4
(Ethernet LAN)
Flashing Green 10/100 Base-T LAN activity is present (traffic in either direction).