User guide

030-300239 Rev. A 10 March 2008
Verizon FiOS Router
(
Model 9100VM
)
User Guide
OFF
Router power is OFF, or no cable or no powered device is
connected to the associated port.
Solid Green A physical connection has been established.
Flashing Green Activity is present on the Coax link.
COAX
OFF Router power is OFF.
Solid Green Wireless link established.
Flashing Green
Wireless LAN activity is present (traffic in either direction).
IP connection established and IP traffic is passing through device
(in either direction). Note: If the IP or PPP session is dropped due
to an idle timeout, the light will remain solid green, if a VDSL2
connection is still present. If the session is dropped for any other
reason, the light is turned OFF. The light will turn red when it
attempts to reconnect and DHCP or PPP fails).
Solid Red
Device attempted to become IP connected and failed (no DHCP
response, no PPP response, PPP authentication failed, no IP
address from IPCP, etc.).
WIRELESS
OFF Router power is OFF or No wireless link.
Rear Panel LEDs
Solid Green Router power is ON.
OFF Router power is OFF.
POWER
Solid Red
POST (Power On Self Test), Failure (not bootable) or Device
Malfunction. Note: The Power LED should be red no longer than
two seconds after the power on self test passes.
Solid Green 100 Mbps link established.
Flashing Green LAN activity at 100 Mbps (traffic in either direction).
Left Ethernet LED
OFF No 100 Mbps link.
Solid Green 10 Mbps link established.
Flashing Green LAN activity at 10 Mbps (traffic in either direction).
Right Ethernet LED
OFF No 10 Mbps link.
5.2 Cable Connectors and Switch Locations
• Reset push button
• Four LAN Ethernet connectors (RJ-45)
• WAN Ethernet connector (RJ-45)
• Power connector (12 VDC) barrel
• OFF/ON power switch
• VDSL2 connector (RJ-11)
• Wireless 802.11b/g SMA connector and antenna