User guide

030-300554 Rev. A 123 June 2008
Verizon FiOS Router
(
Model 9100EM
)
User Guide
NAPT Address: The NAPT address into which the original IP address will be translated. The combo box
displays all of your added NAPT addresses/ranges, from which you can select an entry. If you would like to
add a new address, select the 'User Defined' option in the combo-box. Similarly, this will commence a
sequence that will add a new network object. Note, however, that in this case the network object may only
be an IP address, as NAPT is port-specific.
NAPT Ports: Specify the port(s) of the IP address into which the original IP address will be translated.
Enter a single port or select Range in drop-down list. The screen will refresh, enabling you to
enter a range of ports.
Log Packets Matched by This Rule: Check this check box to log the first packet from a connection
that was matched by this rule.
Schedule: By default, the rule will always be active. However, you can configure scheduler rules by
selecting User Defined, in order to define time segments during which the rule may be active. Refer to
section 15.19 for details on setting up schedule rules.
After you select the desired NAT/NAPT rules, click OK to continue.