User guide

Westell, Inc. Quick Start Guide 8
030-300391 Rev. A May 2004
2A. Installation via 10/100 Base-T/Ethernet Connections
NOTE: Before you connect via 10/100 Base-T, you must have an available Ethernet card installed in
your computer. If your Ethernet card does not auto-negotiate, you must set it to half duplex. Refer to
the Ethernet card manufacturer’s instructions for installing and configuring your Ethernet card.
1. Connect the power supply cord to the power connector marked DC 9V on
the rear panel of VersaLink. Plug the other end of the power supply into a
wall socket.
2. Connect the DSL phone cable from the jack marked
on the rear panel of
VersaLink to the DSL-equipped telephone line jack on the wall.
IMPORTANT: Do not
use a DSL filter on this connection. You must use
the phone cord that was provided with the kit.
3. Connect the yellow Ethernet cable from any one of the Ethernet jacks
marked
on the rear panel of VersaLink to the Ethernet port on your
computer. Repeat this step to connect up to three additional PCs to
VersaLink.
NOTE: You may connect to any of the four Ethernet jacks on the rear panel of VersaLink as
they serve as an Ethernet switch.
4. Check to see if the DSL LED is solid green. If the DSL LED is solid green,
VersaLink is functioning properly.