User guide

Westell, Inc. Quick Start Guide 7
030-300391 Rev. A May 2004
INSTALLING VERSALINK
This section explains the procedures for installing VersaLink. You
may choose to install VersaLink in one of three ways: Ethernet only,
Wireless only, or both Ethernet and Wireless simultaneously. To
install VersaLink via 10/100 Base-T Ethernet only, refer to section
2A. To install VersaLink via Wireless only, refer to section 2B. If
you want to install VersaLink via Ethernet and Wireless ports
simultaneously, refer to section 2C.
NOTE: If you are using VersaLink™ in conjunction with an Ethernet Hub or
Switch, refer to the manufacturer’s instructions for proper installation and
configuration. When using a Microfilter, be certain that the DSL phone cable is
connected to the “DSL/HPN” non-filtered jack. Westell recommends the use
of a surge suppressor to protect equipment attached to the AC power
supply.
When using the optional uplink port (E1), Ethernet LAN connection is limited to
E2, E3, and E4. The UPLINK feature is optional, and if UPLINK is not enabled
in the .ini file, the Router will use DSL and Wireless only.
2