User guide

Westell, Inc. Quick Start Guide 14
030-300391 Rev. A May 2004
2C. Ethernet, Wireless, Combination Hardware Installation
VersaLink™ supports simultaneous use of 10/100 Base-T Ethernet and Wireless
IEEE 802.11b/g ports. The following instructions explain how to install
VersaLink for simultaneous use of Ethernet and Wireless ports.
NOTE: Refer to Figure 1 and Figure 2 for illustrations on hardware installation via Ethernet and
Wireless connections, respectively.
1. Ensure that an 802.11b/g/g+ wireless network adapter has been installed in
each PC on your wireless network
2. Install the appropriate drivers for your Wireless IEEE802.11b or
IEEE802.11g adapter.
3. Make sure the SMA antenna connector is loose. Orient the antenna in the
proper configuration. Then, tighten the antenna knob to lock it into place.
4. The Connect the power supply cord to the power connector marked DC 9V
on the rear panel of VersaLink. Plug the other end of the power supply into
a wall socket.
5. Connect the DSL phone cable from connector marked
on the rear panel
of VersaLink to the DSL-equipped telephone line jack on the wall.
IMPORTANT: Do not
use a DSL filter on this connection. You must use
the phone cord that was provided with the kit.
6. Connect the yellow Ethernet cable from any one of the Ethernet jacks
marked
on the rear panel of VersaLink to the Ethernet port on your