User guide

Westell, Inc. Quick Start Guide 12
030-300391 Rev. A May 2004
To network VersaLink to additional computers in your home or office using a
wireless installation, you will need to confirm the following:
1. Ensure that an 802.11b/g/g+ wireless network adapter has been installed in
each PC on your wireless network.
2. Install the appropriate drivers for your Wireless IEEE802.11b or
IEEE802.11g adapter.
3. Make sure the SMA antenna connector is loose. Orient the antenna in the
proper configuration. Then, tighten the antenna knob to lock it into place.
4. Connect the power supply cord to the power connector marked DC 9V on
the rear panel of VersaLink. Plug the other end of the power supply into a
wall socket.
5. Connect the DSL phone cable from the connector marked on the rear
panel of VersaLink to the DSL-equipped telephone line jack on the wall.
IMPORTANT: Do not use a DSL filter on this connection. You must use
the phone cord that was provided with the kit.
6. Check to see if the DSL LED is solid green. If the DSL LED is solid green,
VersaLink is functioning properly.
7. Check to see if VersaLink’s Wireless LED is solid Green. This means that
the Wireless interface is functioning properly.
Congratulations! You have completed the Wireless installation VersaLink. You
must now proceed to section 3 for instructions on accessing VersaLink.