User guide

030-300505 Rev. A 81 April 2007
User GuideVersaLink Wireless Gatewa
y
(
Model 327W
)
If you clicked the expand button, the following screen will appear. This screen allows you to configure the desired
Routed IP settings for WAN Uplink port.
At the VersaPort screen, do the following:
1. Confirm that Routed IP is selected in the Protocol drop-down menu.
2. Enter the appropriate values in the DHCP Client fields.
3. Set the desired Spanning Tree setting. By default, Spanning Tree is Disabled.
4. Click Apply to allow the settings to take effect.
5. Click OK in the pop-up screen to allow the Router to be reset and the new configuration to take effect.
Uplink Settings (Routed IP protocol)
DHCP Client Selecting a option button allows you to either Enable or Disable the DHCP Client.
Click the top option button labeled (enable DHCP Client) to allow the Router to obtain an IP
address automatically from your service provider.
Click the bottom option button labeled (disable DHCP Client) to allow the Router to accept
static IP address information. Then manually enter the IP values into the fields. Obtain these
values from your service provider.
IP Address The IP network address that your Router is on.
Subnet Mask The subnet mask, which determines if an IP address belongs to your local network.
Gateway The Router’s IP gateway address.
DNS Primary Provided by Verizon.
DNS Secondary Provided by Verizon.
Spanning Tree
Protocol
Factory Default = Disabled
To enable Spanning Tree Protocol, click the box. A check mark will appear in the box.
Note: The values for the IP Address, Gateway, DNS Primary, and DNS Secondary are all “Override of the values
obtained from the PPP connection,” They default to “0.0.0.0,” in which case the override is ignored. It is
recommended that you do not change the values unless your service provider instructs you to change them.