User guide

030-300505 Rev. A 78 April 2007
User GuideVersaLink Wireless Gatewa
y
(
Model 327W
)
If you clicked the expand button, the following screen will appear. This screen allows you to configure the desired
PPPoE settings for WAN Uplink port.
At the VersaPort screen, do the following:
1. Confirm that PPPoE is selected in the Protocol drop-down menu.
2. Enter the appropriate values in the PPPoE Settings fields.
3. Set the desired Tunneling setting (to enable the setting, click the box to place a check mark in the box) or to
disabled the setting, click to clear the box). By default, Tunneling is Enabled.
4. Set the desired Spanning Tree setting (to enable the setting, click the box to place a check mark in the box) or
to disabled the setting, click to clear the box). By default, Spanning Tree is Disabled.
5. Click Apply to allow the settings to take effect.
6. Click OK in the pop-up screen to allow the Router to be reset and the new configuration to take effect.
Uplink Settings (PPPoE protocol)
DHCP Client Selecting a option button allows you to either Enable or Disable the DHCP Client.
Click the top option button labeled (enable DHCP Client) to allow the Router to obtain
an IP address automatically from your service provider.
Click the bottom option button labeled (disable DHCP Client) to allow the Router to