User guide

030-300505 Rev. A 70 April 2007
User GuideVersaLink Wireless Gatewa
y
(
Model 327W
)
13.2.2.4 Configuring the Router’s Protocol Settings for Classical IPoA
To configure your protocol settings for Classical IPoA, access to the VC 1 Configuration screen, as explained earlier
in section 13.2.2.1 “Editing VC Protocol Settings.” At the VC 1 Configuration screen, select Classical IPoA from the
Protocol drop-down menu. The following screen will appear. Enter the appropriate values in the fields provided and
then click Apply.
VC 1 Configuration (Classical IPoA)
VC Status The protocol status is Enabled.
VPI This field allows you to change your VPI (Virtual Path Indicator) value for a
particular VC, which is defined by your Service Provider.
VCI This field allows you to change your VCI (Virtual Channel Indicator) value for a
particular VC, which is defined by your Service Provider.
PCR Factory Default = 100%
Peak Cell Rate (PCR)-The maximum rate at which cells can be transmitted across a
virtual circuit, specified in cells per second and defined by the interval between the
transmission of the last bit of one cell and the first bit of the next.
This value is a percentage of the current data rate.
100 allows this VC to use 100% of the available bandwidth.
80 allows this VC to use 80% of the available bandwidth.
QoS Quality of Service, which is determined by your Service Provider.