User guide

030-300505 Rev. A 144 April 2007
User GuideVersaLink Wireless Gatewa
y
(
Model 327W
)
If you clicked the Public LAN Enable box, the following screen will appear. After you have made changes to this
screen, click Apply to allow the settings to take effect.
If the settings you have entered in the Public LAN Configuration screen are incorrect, the following warning
messages may be appear in pop-up screens. If this occurs, check the Public LAN Configuration settings.
Warning Message Check Public LAN DHCP Settings
Start Address is not part of the Subnet Check the value in the DHCP Start Address field
End Address is not part of the Subnet Check the value in the DHCP End Address field
End Address is below the Start Address Check the value in the DHCP End Address field
Lease time must be greater than 10 seconds Check the values in the DHCP Lease Time fields
Seconds must be between 0 and 59 Check the Seconds field at DHCP Lease Time
Minutes must be between 0 and 59 Check the Minutes field at DHCP Lease Time
Hours must be between 0 and 23 Check the Hours field at DHCP Lease Time
Note: The DHCP Lease Time value must be greater than 10 seconds. The default = 01:00:00:00. Seconds must be
between 0 and 59, minutes must be between 0 and 59, and hours must be between 0 and 23.
If you clicked Apply in the preceding screen, the following pop-up screen will appear. The Router must be reset to
allow the new configuration to take effect. Click OK to continue.