User guide

030-300505 Rev. A 14 April 2007
User GuideVersaLink Wireless Gatewa
y
(
Model 327W
)
3. Connect an Ethernet cable from any one of the three Ethernet jacks marked E2, E3, or E4 on the rear panel of
the VersaLink to the Ethernet port on your computer. Repeat this step to connect up to three additional PCs to
VersaLink; each jack serves an Ethernet switch.
4. Connect the power supply cord to the power connector marked DC 12V on the rear panel of the VersaLink.
Plug the other end of the power supply into an AC wall socket, and then turn on the power (if it is not on).
5. Check to see if the VersaLink’s POWER LED is solid green. This indicates that VersaLink is powered on.
6. Check to see if the ETHERNET LED is solid green. Solid green indicates that the Ethernet connection is
functioning properly. Check the ETHERNET LED for the Ethernet jack you are using on VersaLink.
7. After you have logged on to your account and established an Internet connection, as explained later in section 7,
check to see if the VersaLink’s INTERNET LED is solid green. Solid green indicates that an Internet link has
been established. (Flashing green indicates the presence of IP traffic.)
Congratulations! You have completed the UPLINK/E1 installation for VersaLink. No software installation is required
when using the UPLINK connection. Now proceed to section 7 to access VersaLink’s Web pages.