Specifications

CopyDisc Duplicator Series
51
Adjusting the Printer Position
Correct alignment of the Puma on the CopyDisc system is essential to ensure the unit works
efficiently. If your system has problems picking up from the OptiPrinter Pro the following
procedures should help to solve the problem.
Note:
Lack of accuracy in setting the pick up position will lead to miss-picks and dropped discs.
To ensure accuracy follow these steps:-
7. Have the printer and CopyDisc in a state where there are no jobs running.
8. Scroll down to Utilities using the ▼ key and press ►
9. Use the ▼ key to select Loader Utilities and press ►
10. Use the ▼ key to select ‘Input Bin to Printer’ and press ►
11. The printer tray will open and a disc will be placed onto the tray.
12. Examine where exactly the disc has been placed on the tray. The disc must be
0.5mm (0.0197”) from the 2 front pins on the drawer and be on equal distance from each pin.
11. Determine which way the printer needs to move to receive the disc properly.
12. Loosen the retaining screws on the printer plate and make the adjustment (it may help to
mark its current position before moving in case it slips).
13. Use the ▼ key to select ‘Printer to Output Bin’. The disc will be taken from the printer.
14. Go back to step 4 to check the alignment.
15. Once the printer plate is in position, tighten the screws on the plate.
Fig. F4