Specifications

CopyDisc Duplicator Series
48
Carefully position the printer onto the printer plate (figure F2) ensuring that the location pins fit
snugly into the location holes on the base of printer itself.
Power On
Connect the parallel cable and the serial control cable to the printer (figure F3). Now connect the
respective Power Cables to the printer and the CopyDisc duplicator and connect to the mains.
Press the power on key on the front of the printer first followed by the power on key at the back of
your CopyDisc duplicator.When turning power off, switch off the printer first followed by the
CopyDisc.
Adjusting the Printer Position
Correct alignment of the Puma on the CopyDisc system is essential to ensure the unit works
efficiently. If your system has problems picking up from the Puma the following procedures should
help to solve the problem.
Note:
Lack of accuracy in setting the pick up position will lead to miss-picks and dropped discs.
Fig. F3
Parallel cable
Serial cable
Power cable
Fig. F1 Fig. F2
Location pins