Specifications

CopyDisc Duplicator Series

Press the “power on” button on the back of the printer. The display on the printer should read

Ready. Press the Select button until the LCD display shows Interface…. The printer should be

factory set to read Interface Parallel. If this is the case, press the Select button again until the

screen reads Ready.

Note:

If the printer reads Interface USB, press Enter then Select to change it to Interface

Parallel. Press Enter. You will now need to power off the printer and power on again.

Press the “power on” button on the back of the CopyDisc which will then go through a series of

self-tests. The Print Only Mode prompt will appear.

Adjusting the Printer Position

Your CopyDisc 4P-55 now needs to be aligned so that when a CD is released into the printer it fits

into the correct position in the CD tray.

1. Switch on your TEAC P-55 printer followed by the CopyDisc duplicator.

2. Open the printer tray by pressing the Load/Eject button on the front of the printer.

3. On the LCD panel on the front of the CopyDisc unit move the > cursor using the arrow keys

until it is level with the Utilities and press the > key. Now scroll down to Loader Utilities

and press the > key.

4. Move the > cursor to Calibrate and press the > key. The robotic arm re-sets itself.

5. Place a disc onto the Input spindle, move the > cursor to Input Bin to Printer and press

the > key. The robotic arm picks the disc from the Input spindle and places it into the printer

tray. Check to see if the disc is situated in the correct position within the tray. The disc

should sit on the rubber pad between the two alignment pins and the centring pin (figure

H6). If the disc is resting on the alignment pins, the printer will not close or print.

6. If the disc does sit centrally, the printer position in relation to the CopyDisc unit needs to be

adjusted. Gently tap the plate in the direction required to align the printer.

7. Once again, place a disc onto the Input spindle, move the > cursor to Input Bin To Printer

and press the > key. The robotic arm picks and places the disc from the Input spindle and

places it into the printer drawer. Continue this process until the disc is placed correctly into

the printer tray.

8. Continue this process until the CD is placed correctly into the CD tray.

Fig. H6

3 Pins