Specifications

CopyDisc Duplicator Series

Appendix H: CopyDisc Systems with Teac P-55 Thermal Printer

The section will provide you with detailed information on how to set up and operate your

CopyDisc 4P-55 Platinum combined duplicator and TEAC P-55 thermal re-transfer printer.

Note:

Good quality, thermal printable discs (specific for thermal re-transfer printing) should be

used with the CopyDisc 4P-55.

Note:

Your CopyDisc4 P-55 is fitted with a vacuum picker. The mechanical picker is not

compatible with the CopyDisc 4 P-55.

Box Contents

Carefully remove the CopyDisc duplicator and the TEAC P-55 printer from its shipping cartons and

verify that all parts are present. If there are missing or damaged parts contact Verity Systems or an

authorised partner/reseller immediately to correct any miss-packed or missing parts.

You should find the following:

 Verity Systems CopyDisc duplicator with four DVD drives

 TEAC P-55 thermal retransfer printer

 Printer plate with four screws with four washers

 Support Bracket

 Power Cable

 Printer parallel cable (Cannon ‘D‘ 25 way) and serial cable connector

 Power Connector Cable

 Input and Output Spindles

 One photo and one transfer ribbon

 User Manual CD and Quick Start Guide

 Printer Manual and Software CD

 Warranty Card

 Networking software CDs – if applicable (DiscPilot Client/CD label Designer CD,

PublisherNET Server CD and Nero software CD)

Fitting the Thermal Ribbon

Your TEAC P-55 thermal printer will come with a photo and a transfer thermal ribbon. For details

on how to fit the ribbons, please see the TEAC P-55 printer manual on the Utility Software CD

included with your printer.

Attaching your Printer and Duplicator

Your CopyDisc 4P-55 will come with the printer plate, which needs to be fitted to the CopyDisc

unit before the printer can be fitted.

Remove the four screws from the back of the CopyDisc unit, and fix the Support Bracket to the

back of the CopyDisc unit using the same four screws (figure H1).

Place the printer plate onto the CopyDisc unit as shown below (figure H2) matching the holes on

the plate with the holes on the CopyDisc unit. Screw the plate into place. Do not tighten the screws

completely.