Specifications

CopyDisc Duplicator Series

Adjusting the Printer Position

Your CopyDisc 4P now needs to be aligned so that when a disc is released into the printer it fits

snugly in the printer tray.

1. Switch on the Prism printer followed by the CopyDisc duplicator.

2. Open the printer tray by pressing the key on the front of the printer (figure G5)

3. On the LCD panel on the front of the CopyDisc unit move the > cursor using the arrow

keys until it is level with the Utilities and press the > key. Now scroll down to Loader

Utilities and press the > key.

4. Move the > cursor to Calibrate and press the > key. The robotic arm re-sets itself.

5. Place a disc onto the Input spindle, move the > cursor to Input Bin to Printer and press

the > key. The robotic arm picks the disc from the Input spindle and places it into the

printer tray. Check to see if the disc is situated in the correct position within the tray. The

disc should sit on the rubber pad between the two alignment pins and the centring pin

(figure G6). If the disc is resting on the alignment pins, the printer will not close or print.

6. If the disc does not fit within the alignment and centring pins, the printer’s position in

relation to the CopyDisc unit needs to be adjusted. Loosen the printer plate screws (do not

remove them completely) and gently tap the plate in the direction required to align the

printer.

7. Once again, place a disc onto the Input spindle, move the > cursor to Input Bin To

Printer and press the > key. The robotic arm picks and places the disc from the Input

spindle and places it into the printer drawer. Continue this process until the disc is placed

correctly into the printer tray.

8. Before tightening the screws on the printer plate, you need to ensure that discs removed

directly from the drives will also position correctly in the printer tray. Ensure the printer tray

is open.

9. Place discs into all drives and allow the discs to spin up and down.

10. On the LCD panel move the > cursor to Drive to Printer, select Drive 1 and then press

the > key. The robotic arm will lift the disc from the drive and place it into the printer tray.

Fig. F6

Alignment Pins

Centering Pins

Fig. G5

Open printer tray