Specifications

CopyDisc Duplicator Series

Unscrew and remove the 4 screws and washers positioned on the top of the CopyDisc drive

tower.Turn the printer with plate the correct way up and place the printer and plate over the top of

the CopyDisc drive tower matching up the corresponding holes in each corner of the plate with

those in each corner of the CopyDisc unit and then loosely screw into place with the four screws

and washers just removed, (figure G3).

Note:

Do not tighten the screws at this point, as some adjustments to the plate’s position may be

required.

Power On

1. Connect the parallel cable to the back of the CopyDisc and then to the back of the printer

(figure G4).

2. Connect the printer to the CopyDisc unit using the power connector cable.

3. Now connect the power cable to the back of CopyDisc duplicator and connect to the mains

(figure G4).

4. Press the power on switch on the printer, located at the back of the printer followed by the

power on switch at the back of your CopyDisc duplicator. When switching off your

CopyDisc 4P, switch-off the printer first followed by the CopyDisc.

Fig. G3

Fig. G4

Parallel Cable

CopyDisc Power On

Power Cable

Printer Power On