Specifications

CopyDisc Duplicator Series

Appendix G: CopyDisc systems with Prism AutoPrinter

The section will provide you with detailed information on how to set up and operate your

CopyDisc 4P combined duplicator and printer fitted with a Prism thermal printer.

Note:

Your CopyDisc 4P is fitted with a vacuum picker. The mechanical picker is not compatible

with the CopyDisc 4P.

Box Contents

Carefully remove your CopyDisc duplicator and printer from their shipping cartons and verify that

all parts are present. If there are missing or damaged parts contact Verity Systems or an

authorised partner/reseller immediately to correct any miss-packed or missing parts.

You should find the following:

 Verity Systems CopyDisc robot (fitted with 4 DVD drives)

 Prism thermal printer, fitted with a colour thermal ribbon

 Printer Plate (with 4 fixing screws and washers)

 Power Cable x 2

 Printer parallel cable and printer serial cable

 Input and output spindles

 User Manual CD and Quick Start Guide

 Printer Manual Folder (hard copy) and Software

 Warranty Card

 Networking software CDs – if applicable (DiscPilot Client/CD label Designer CD,

PublisherNET Server CD and Nero software CD)

Attaching your Printer and Duplicator

The printer first needs to be attached to the printer plate before fixing it to the CopyDisc unit.

Carefully turn the printer up side down and remove the four feet on the base of the printer (figure

G1). Place the printer plate on top of the printer, matching the holes on the plate with the feet.

Secure the plate in place using the four small silver screws included (figure G2).

Remove all 4 feet

Fig. G1

Fig. G2