Specifications

CopyDisc Duplicator Series

3.4.8 Setup

These menus are used to select various options available on the CopyDisc

duplicator.

3.4.8.1 Printer

This option allows the printer type to be selected.

Under Model, position the > cursor next to the printer you wish to select and then

press the > key.

Under Status, select whether you wish the printer to be connected or not by

positioning the > cursor next to either connected or disconnected and then press

the > key.

3.4.8.2 Autoloader

Your CopyDisc should be factory set to Publisher for 220 capacity CopyDisc

systems, or Autoloader D for CopyDisc XC (660 capacity) systems.

Under Status, select whether you wish the autoloader to be connected or not by

positioning the > cursor next to either enable or disable and then press the > key.

3.4.8.3 Optical Drive

If you want to disable a writer drive set it to Disable. This menu is used to disable a

writer that may be faulty. Normally all writers would be Enabled.

NOTE:

Only writers found will be shown in this menu. If a writer is missing from this menu it is not

correctly functioning.

3.4.8.4 Licence Key

This menu function allows you to add, remove and view licence keys. Please note

you should not access this menu unless instructed to do so by authorised Verity

Systems personnel.

3.4.8.5 Operation

This menu allows the user to change operating mode from synchronous to

asynchronous production.

3.4.8.6 Menu

This menu function allows you to change the menu view on the CopyDisc. Please

note you should not access this menu unless instructed to do so by authorised

Verity Systems personnel.