Specifications

CopyDisc Duplicator Series

2.5 Start Printing (From a pre-created print file (PRN file) on a CD)

This section is only applicable to CopyDisc systems fitted with an integrated Printer.

This quick start section assumes the Printer Setup Options are set as shipped from the factory. If

they are not or if these instructions do not work then go to the Operation chapter (section 3) of this

manual for detailed operating instructions.

1. Load blank printable discs into the input spindle

2. Load the master disc containing the PRN on top of the blanks in the input spindle

3. Use the up /\ or down \/ arrow keys to move the > cursor on the control panel to Print Only

Mode

4. You will be asked if you wish to read a new PRN file, use the > key to select yes.

5. You will be asked if you wish to save the PRN to the HDD, use the > key to select yes.

6. Enter the quantity of discs required using the up /\ or down \/ arrow and press START.

The loader will then start loading discs into the printer drawer to begin the printing process.

7. If you were to select No at the ‘read new PRN file’ option, a list of all PRN images on the

hard drive (if more than one) will appear on the control panel. Scroll down to select the PRN

you wish to use and then press the > key

8. If you were to select No at the ‘save PRN file to HDD’ option, Printing would begin as

normal, but your PRN file would not be stored on the HDD for future use.

CAUTION!

Never turn the power off during a copy cycle. You will not only waste the CDs you are

burning but you could damage the CopyDisc duplicator and drives.