User`s guide

Getting Started

To enable or disable data logger channels:

1. Do one of the following:

• Select Logger>Channels...

• You can also enable or disable data logger channels by selecting Log-

ger>Setup (or pressing F11 or clicking the Logger Setup icon on the

toolbar ( )). Then, in the Logger Setup window, click the Setup... but-

ton beside the channel you want to enable or disable.

2. In the window that appears, select or deselect the checkbox to enable or dis-

able a channel.

3. Click OK. This initiates the process of clearing the data logger’s memory.

Note:

• A channel must be enabled before it can start collecting readings.

• It is a good idea to disable unused channels to maximize logger memory.

• If you are using a temperature and humidity data logger, remember that the

humidity sensor requires temperature values. You cannot disable the tem-

perature sensor channel if you are using the humidity channel.

Configuring Channels to Work with Transducers

This section applies only to those using Veriteq VL-4000 and SP-4000 series

data loggers. Used with transducers, you can configure VL-4000 and SP-4000

series data loggers to display measurements in units other than milliAmps or

volts.

To configure VL-4000 and SP-4000 loggers to work with transducers:

1. In vLog, choose Logger>Setup.

2. From the Setup window, click Setup next to the channel to configure.

Different loggers offer different channel types, each with different setup win-

dows and slightly different steps. In general, configure the logger’s typical units

and range to reflect the units and range you want to display.