Installation Guide

STEP THREE
With the jaw fully extended, swing the VersiShield over
the edge of the stair structure and rest the base on the
stair tread (See Figure 3).
Unhook the locking mechanism from the ring and slide
down onto the top plate, lift stanchion using the lift ring
and place locking mechanism into corresponding hole
(See Figure 4).
Tighten the central tension bolt while holding the stan-
chion in place. Firmly move the stanchion back and forth
while tightening the tension bolt so that the stanchion is
secured underneath and perpendicular to the bottom of
the stair structure (See Figure 5).
Securely tighten the central tension bolt using a 15/16
inch wrench or socket. DO NOT OVER TIGHTEN!
INSTALL CLAMP AND POST ONTO THE STAIR STRUCTURE
Figure 3
Figure 5
90°
Figure 4