Install

Electrical Connections
Hardware Installation
1) Mount the A8332-8F2D on a DIN-Rail or
appropriate mounting enclosure.
2) Attach the power supply to the input terminals on
the A8332-8F2D module.
3) Attach the RS485 +, - and shield wires to the
A8332-8F2D module. Attach the other end of the
RS485 line to the Modbus master device, such as
an AcquiSuite. Be careful to observer polarity on
both ends of the RS485 connection. RS485 wiring
runs should be limited to 4000 ft.
4) Set the Modbus address dipswitches and baud rate
dipswitch. For more information on the switch
options, see the section below for configuration.
5) Turn on the power supply. Confirm the green
Alive LED starts blinking about once per second.
6) Check the RS485 yellow LEDs.
Page 6 A8332-8F2D