User guide

► To Set the ACTION:

1. Press “95” + hold the [PRESET] key for 2 seconds to enter the main menu

screen.

2. Move the cursor to <SYSTEM>, and then press the [OPEN] key <SYSTEM>

menu.

3. Move the cursor to the ACTION selection and then move the joystick

up/down to set AUTO RETURN or PARK.

4. Press the [OPEN] key to confirm the selection or press the [CLOSE] key to

cancel selection and exit from the menu screen.

Pattern Tour

The Nextiva S5500 IP PTZ cameras provides four sets of patterns and playback

modes for selection. Actions for playback include lens zoom, horizontal pan,

and vertical tilt etc. Once the pattern is recorded, it can be played back

accordingly to the user’s discretion. Each set can record up to 6 minutes and up

to 4 sets (24 minutes) of patterns recorded.

Pattern tour configuration:

1. Record:

Press “101” + [PRESET] key for 2 seconds → Begin first set

Press “102” + [PRESET] key for 2 seconds → Begin second set

Press “103” + [PRESET] key for 2 seconds → Begin third set

Press “104” + [PRESET] key for 2 seconds → Begin fourth set

Stop recording: Press “105”+ [PRESET] key

2. Playback:

Press “101” + [PRESET] key → Playback first set

Press “102” + [PRESET] key → Playback second set

Press “103” + [PRESET] key → Playback third set

Press “104” + [PRESET] key → Playback fourth set

Note

When the user is recording a pattern, the OSD cannot be accessed to modify

an action, as the pattern recording will be interrupted.

The ongoing pattern would keep being performed after powered up from

abnormal power lost; regardless of the setting for power menu.

Chapter 4: Configuring the Nextiva S5500 PTZ Series Properties