User guide

► To set the Power Up Mode:

1. Press “95” + hold the [PRESET] key for 2 seconds to enter the main menu

screen.

2. Move the cursor to <SYSTEM>, and then press the [OPEN] key <SYSTEM>

menu.

3. Move the cursor to the POWER UP selection and then press the [OPEN] key.

4. Move the joystick up/down to set the power up mode.

5. Press the [OPEN] key to confirm the selection or press the [CLOSE] key to

cancel selection and exit from the menu screen.

Load Factory Default

<SYSTEM> → LOAD FACTORY DEFAULT

► To load the Factory Default:

1. Press “95” + hold the [PRESET] key for 2 seconds to enter the main menu

screen.

2. Move the cursor to <SYSTEM>, and then press the [OPEN] key <SYSTEM>

menu.

3. Move the cursor to LOAD FACTORY DEFAULT, and then press the [OPEN] key

twice to show the screen: LOAD FACTORY DEFAULT and the setup is

complete.

Note

Please do not operate keyboard when “*” appear; wait for arrows showing on

screen.

E-FLIP

<SYSTEM> → E-FLIP

► To set as E-Flip:

1. Press “95” + hold the [PRESET] key for 2 seconds to enter the main menu

screen.

2. Move the cursor to <SYSTEM>, and then press the [OPEN] key <SYSTEM>

menu.

3. Move the cursor to the E-FLIP selection and then press the [OPEN] key E-

FLIP menu.

4. Move the joystick up/down to set ON or OFF.

5. Press the [OPEN] key to confirm the selection or press the [CLOSE] key to

cancel selection and exit from the menu screen.

Chapter 4: Configuring the Nextiva S5500 PTZ Series Properties