User guide

[OPEN] key.

4. Move the joystick up/down to set tilt angle (0~92°).

5. Press the [OPEN] key to confirm the selection or press the [CLOSE] key to

cancel selection and exit from the menu screen.

Schedule

Four sets of schedules can be configured with individual start time, end time,

and action mode. The actions include preset(0~32), auto scan, auto patrol 1~4,

frame scan, and random scan modes.

► To set a Schedule:

1. Press “95” + hold the [PRESET] key for 2 seconds to enter the main menu

screen.

2. Move the cursor to <OTHERS>, and then press the [OPEN] key <OTHERS>

menu.

3. Move the cursor to <SCHEDULE>, and then press the [OPEN] key the

<SCHEDULE> menu.

4. Move the cursor to WEEK and then press the key. Use the joystick up/down to

select the week and press the key to confirm the selection and quit.

5. Move the cursor to ENABLE and press the key to enter the option. Use the

joystick up/down to set ON or OFF.

6. Press the key to set the start time, end time, and status options.

7. Move the joystick up/down to make the selection.

8. Press the [OPEN] key to confirm the selection or press the [CLOSE] key to

cancel selection and exit from the menu screen.

Note

1. The Start and End time setup is by the unit of hours. For example, set 0 ->

1 means from 00:00 to 01:59, 2 hours in total.

2. When a schedule mode is ON and within the schedule time interval, the

dome will still perform scheduling after power up from abnormal power

lost; regardless of the setting for power on Menu.

Schedule